If your vocal sounds crunchy, thin, or randomly distorted, its usually not the mic its the level. Gain staging is just keeping every step of the chain in a healthy range so nothing clips and nothing gets buried in noise.
1) Start at the source: performance distance and consistency
Before touching knobs, set the performer up right: pop filter in place, consistent distance, and a comfortable headphone mix.
If the artist is moving in and out, your compressor will pump and your EQ decisions wont translate.
2) Preamp gain: aim for clean peaks
A safe target: average around -18 dBFS with peaks around -10 to -6 dBFS.
If youre hitting red on the interface, youre already too hot and you cant fix that later.
3) Compression: control, dont crush
Use compression to make the vocal consistent, not smaller. Start with moderate settings and listen for the vocal staying forward without sounding squeezed.
If sibilance gets worse, thats a clue youre compressing too hard or too fast.
4) EQ after compression (most of the time)
Compression can bring up mud and harshness. EQ after compression lets you clean what the compressor revealed.
Do small moves. If you need extreme EQ, the recording setup needs adjusting.
5) Keep plugin output levels honest
A common mistake: every plugin adds 12 dB, and by the end youre clipping the channel.
After each plugin, level-match the output so the next plugin receives a similar level.
6) Final check: vocal bus and stereo bus headroom
Make sure your vocal bus isnt clipping and your stereo bus still has headroom (peaks around -6 dBFS before limiting).
If the vocal is loud but the mix is small, its usually a balance issue not a louder vocal.
Key Takeaway
Clean gain staging makes mixing easier. If you keep every step of the chain healthy, your vocal will get louder without getting uglier.
Want your vocals to sound radio-clean? See our production services or book a session.
Ready to record?
Book a Session